SOtM docs

Trace:

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Next revision		Previous revision
en:how_to_replace_sdp-1000_battery_pack [2016/11/16 22:35] – created sanghoonen:how_to_replace_sdp-1000_battery_pack [2020/01/10 13:51] (current) – admin
Line 1: Line 1:
-sDP-1000 Battery Replacement Instruction+sDP-1000, sDP-1000EX Battery Replacement Instruction
  
 <note important> <note important>
 **CAUTION** **CAUTION**
-  * If circumstances allow, ask replacement to distributor or retail shop. +  * If circumstances allow, ask your dealer for a replacement. 
-  * Be careful not to overtighten screws. +  * Be careful not to overtighten the screws. 
-  * Please recycle your used batteries that have explosion risk+  * Please recycle the used batteries as they have an explosion risk.
 </note> </note>
  
Line 16: Line 16:
 {{ :en:capture_20161117123024.png |}} {{ :en:capture_20161117123024.png |}}
   - Unscrew the four remaining screws on the battery holder plate.   - Unscrew the four remaining screws on the battery holder plate.
-  - Unwrap the tape the nylon reinforced tape from the batteries/back-plate.+  - Unwrap the nylon reinforced tape from the batteries and the back-plate.
  
 {{ :en:capture_20161117123040.png |}} {{ :en:capture_20161117123040.png |}}
-Carefully pry the battery packs off the back plate by using tools such as straight razor+Carefully pry the battery packs off the back plate using a tool such as a straight razor.
  
 {{ :en:capture_20161117123056.png |}} {{ :en:capture_20161117123056.png |}}
Line 25: Line 25:
  
 {{ :en:capture_20161117123110.png |}} {{ :en:capture_20161117123110.png |}}
-Remove backing on the two way tape from the new battery; center carefully on the two holes and make a little space between two batteries.+Remove peels of tape from the new battery pack. Center it carefully on the two holes, making a little space between the two batteries.
  
 {{ :en:capture_20161117123128.png |}} {{ :en:capture_20161117123128.png |}}
Line 34: Line 34:
  
 {{ :en:capture_20161117123157.png |}} {{ :en:capture_20161117123157.png |}}
-Holding the new battery pack at an angle above the opening, plug the outer (battery) terminals in.+Hold the new battery pack at the angle like the image above, and plug the outer (battery) terminals in.
  
 {{ :en:capture_20161117123211.png |}} {{ :en:capture_20161117123211.png |}}
-Screw the battery holder plate (outer four) screws in place, making sure the foot is positioned in the lower, outside corner.+Screw the battery holder plate (outer four) screws in place, and make sure the foot is positioned in the lower and outside corner.
Last modified: 2016/11/16 22:35

Copyright © 2008-2026 SOtM. All rights reserved.