This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| en:how_to_enable_gigabit_ethernet_in_sms-200 [2020/01/07 16:01] – [Disassemble the front case] admin | en:how_to_enable_gigabit_ethernet_in_sms-200 [2020/01/07 16:09] (current) – [Remove 'C670' Chip Capacitor] admin | ||
|---|---|---|---|
| Line 13: | Line 13: | ||
| ===== Disassemble the rear case ===== | ===== Disassemble the rear case ===== | ||
| - | Unscrew 4 points of Torx screws as like the image below. {{ : | + | Unscrew |
| ===== Remove ' | ===== Remove ' | ||
| - | Pull out the rear case very carefully to disassemble the main board from the body case. Remove ' | + | Pull out the rear case very carefully to disassemble the main board from the body case. Remove ' |
| ===== Assemble sMS-200 cases ===== | ===== Assemble sMS-200 cases ===== | ||