This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| en:how_to_enable_gigabit_ethernet_in_sms-200 [2017/01/12 03:08] – [Start Restore] sanghoon | en:how_to_enable_gigabit_ethernet_in_sms-200 [2020/01/07 16:09] (current) – [Remove 'C670' Chip Capacitor] admin | ||
|---|---|---|---|
| Line 5: | Line 5: | ||
| ===== Disassemble the front case ===== | ===== Disassemble the front case ===== | ||
| - | Unscrew 4 points of Torx screws as like the image below. {{ : | + | Unscrew |
| ===== Disassemble the LED board ===== | ===== Disassemble the LED board ===== | ||
| Line 13: | Line 13: | ||
| ===== Disassemble the rear case ===== | ===== Disassemble the rear case ===== | ||
| - | Unscrew 4 points of Torx screws as like the image below. {{ : | + | Unscrew |
| ===== Remove ' | ===== Remove ' | ||
| - | Pull out the rear case very carefully to disassemble the main board from the body case. Remove ' | + | Pull out the rear case very carefully to disassemble the main board from the body case. Remove ' |
| ===== Assemble sMS-200 cases ===== | ===== Assemble sMS-200 cases ===== | ||
| Line 25: | Line 25: | ||
| ====== Software ====== | ====== Software ====== | ||
| - | Change | + | To change |
| ===== Windows ===== | ===== Windows ===== | ||
| Line 56: | Line 56: | ||
| ===== macOS ===== | ===== macOS ===== | ||
| - | <note warning> | + | |
| ==== Preparation ==== | ==== Preparation ==== | ||
| Line 64: | Line 64: | ||
| - Eject the micro SD card from the rear case of sMS-200 and insert to PC USB port by using the micro SD card reader. | - Eject the micro SD card from the rear case of sMS-200 and insert to PC USB port by using the micro SD card reader. | ||
| - | ==== Select File to Restore==== | ||
| - | {{ : | ||
| ==== Start Restore==== | ==== Start Restore==== | ||