Eunhasu CMD URL

This feature is supported from Eunhasu V0.6.5.

CMD URL (App control URL) lets you start, stop, and restart apps on your Eunhasu device and check their status by entering a URL in your browser's address bar. You can control an app with a single URL without navigating through the Web GUI menus.

Use it from a web browser on a PC or smart device connected to the same network as the Eunhasu device. In the instructions below, replace <IP> with the IP address of your device (e.g. 192.168.0.38).

Enter the address below in your browser's address bar to see the list of controllable apps, the current status of each app, and the URLs to use.

http://<IP>/cmd/

• app: The name of the app to control.
• status: The current status of the app. 'active' means running, and 'inactive' means stopped.
• start / stop / restart: The URLs used for each action.

Enter the URL in the format below, adding Start, Stop, or Restart after the app name.

http://<IP>/cmd/<app name><action>

After you enter a URL, the result is shown in a single line. 'OK' means the command was processed successfully, and the status after the action is shown after the arrow (→).

OK    roonready  start  ->  active

Add Start after the app name. If the result shows 'active', the app has started.

Refresh the Eunhasu home screen, and the app is shown as 'Active'.

Add Stop after the app name. If the result shows 'inactive', the app has stopped.

Refresh the Eunhasu home screen, and the 'Active' label disappears and the app name (Roon Ready) is shown.

Add Restart after the app name. The app stops and starts again, and the result shows 'active'. Use this when an app is not working properly.

The apps you can control with CMD URL are listed below. Each app's URL is http://<IP>/cmd/ followed by the app name and the action (e.g. mpdStart, mpdStop, mpdRestart).